Haven't found a suitable solution?
We offer full service - from the idea to implementation.
Regardless of whether it is a customer-specific adaptations of our products or a new development of your individual wireless solution.
The DMS-12 is designed for use in large institutions. The alarm system is ready to use in no time and there is no expensive laying of cables. Installation is extremely easy and operation is intuitive right form the start. The bi-directional wireless system consists of a base station, alarms or pull switches, while portable receivers and repeater stations can be used as options to extend the wireless range. In addition, signalers can be used for the additional indication of calls and can be used both as room signal lamps and for the creation of site plans or similar. The modular structure of the system allows for simple extension with very little installation work or cost. The entire system monitors itself and reports any faults immediately to the control centre and, as an option, to the portable receivers, too. Problems such as low battery power or poor wireless communication with a component are displayed immediately and can therefore be resolved at an early stage.
The DMS-12 call and alarm system offers a wide range of advantages and possibilities.
Our call and alarm systems are characterised by their intelligent wireless communication. With extremely short response times, the frequency channel is tied up for a minimum amount of time. The special transmission characteristics familiar from the SH-12 wireless series ensure extremely low interference during operation. Thanks to this wireless transmission that is immune to interference, ranges of over 100 m can be achieved inside buildings, depending on the circumstances. At the same time, ergonomics and design bring an appealing external appearance and technology together in harmony. For strong, narrow-band interference or use of several parallel wireless systems, the working frequency can be set to meet individual needs. The DMS-12 is programmed with a serial number in the factory. This provides greater security and turns every call system into a unique network that can be distinguished easily.
Here is a small selection of the areas in which the alarm system has already proved itself:
In a rehab clinic, for example, the alarms are installed in the patients' bedrooms. Pull buttons are attached to every shower and WC in the building. The care staff have portable receivers and are notified of an incoming call whenever it arrives. A signaler is installed in front of the room which lights up red in case of a call in the room. Repeaters not only ensure wireless communication within the multi-storey building but also link the neighbouring building into the system. The control centre is set up at reception.
We will be happy to provide you with individual advice on selection and design of your call and alarm system or integration of your components. You will find further information in our DMS-12 brochure
Preis auf Anfrage
|Order reference:||DMS-12 call and alarm system|
|Temperature range:||0°C to +50°C|
|Power supply:||12,0V - 24,0V DC, by plug-in power supply 230V AC|
|Outputs:||2 x relay by screw terminals, located internally|
|Frequency:||433,62 MHz to 434,22 MHz|
|Scope of supply:||Receiver base with multi-flex antenna and plug-in power supply|
|Current consumption:||approx. 0,5A|
|Dimensions:||approx. 290 x 200 x 120 mm|
|EAR Registrierungsnummer:||WEEE-Reg.-Nr. DE 31113729|